座位

Durethan® is the trade name for our range of engineering thermoplastics based on polyamide 6 and polyamide 66. These polyamides are partially crystalline thermoplastics which offer an ideal combination of properties, especially for technical applications. They provide high mechanical strength and stiffness, good dielectric properties, high resistance to both heat and chemical attack, and good friction and wear properties.

Tepex® dynalite 102-RG600(x)/47%Roving Glass - PA6 consolidated composite laminate\r\nThe datasheet is valid for this specific composition only, the characteristics of composites depend on reinforcement level and fiber orientation. Non-standard thickness may alter some or all of these properties. The data listed here are given as average product properties and should not be used to establish specification limits nor used alone as basis of design. The underlying tests were conducted at room temperature and (where possible) with 2 mm specimen thickness. For tensile and flexural tests a specimen width of 25 mm was used and is highly recommended to achieve representative results.

Tepex® dynalite 102-RG600(x)/47%Roving Glass - PA6 consolidated composite laminate\r\nThe datasheet is valid for this specific composition only, the characteristics of composites depend on reinforcement level and fiber orientation. Non-standard thickness may alter some or all of these properties. The data listed here are given as average product properties and should not be used to establish specification limits nor used alone as basis of design. The underlying tests were conducted at room temperature and (where possible) with 2 mm specimen thickness. For tensile and flexural tests a specimen width of 25 mm was used and is highly recommended to achieve representative results.

Tepex® dynalite 102-RG600(x)/47%Roving Glass - PA6 consolidated composite laminate\r\nThe datasheet is valid for this specific composition only, the characteristics of composites depend on reinforcement level and fiber orientation. Non-standard thickness may alter some or all of these properties. The data listed here are given as average product properties and should not be used to establish specification limits nor used alone as basis of design. The underlying tests were conducted at room temperature and (where possible) with 2 mm specimen thickness. For tensile and flexural tests a specimen width of 25 mm was used and is highly recommended to achieve representative results.

Akulon®是高性能PA6和PA66家族，客户遍布全球，广泛应用于汽车、电子电气、家具、包装等行业。

我们提供注塑级、吹塑级和挤出级的Akulon®牌号，其中挤出级包括阻隔膜、棒材、波纹管和单层多层膜。

用此材料注塑时，在设计简单和卓越的机械性能间能达到完美的平衡，应用种类多，温度范围广。用作挤出时，Akulon®的强度、回弹性和加工简便都是市场标杆。