좌석

Durethan® is the trade name for our range of engineering thermoplastics based on polyamide 6 and polyamide 66. These polyamides are partially crystalline thermoplastics which offer an ideal combination of properties, especially for technical applications. They provide high mechanical strength and stiffness, good dielectric properties, high resistance to both heat and chemical attack, and good friction and wear properties.

Tepex® dynalite 102-RG600(x)/47%Roving Glass - PA6 consolidated composite laminate\r\nThe datasheet is valid for this specific composition only, the characteristics of composites depend on reinforcement level and fiber orientation. Non-standard thickness may alter some or all of these properties. The data listed here are given as average product properties and should not be used to establish specification limits nor used alone as basis of design. The underlying tests were conducted at room temperature and (where possible) with 2 mm specimen thickness. For tensile and flexural tests a specimen width of 25 mm was used and is highly recommended to achieve representative results.

Tepex® dynalite 102-RG600(x)/47%Roving Glass - PA6 consolidated composite laminate\r\nThe datasheet is valid for this specific composition only, the characteristics of composites depend on reinforcement level and fiber orientation. Non-standard thickness may alter some or all of these properties. The data listed here are given as average product properties and should not be used to establish specification limits nor used alone as basis of design. The underlying tests were conducted at room temperature and (where possible) with 2 mm specimen thickness. For tensile and flexural tests a specimen width of 25 mm was used and is highly recommended to achieve representative results.

Tepex® dynalite 102-RG600(x)/47%Roving Glass - PA6 consolidated composite laminate\r\nThe datasheet is valid for this specific composition only, the characteristics of composites depend on reinforcement level and fiber orientation. Non-standard thickness may alter some or all of these properties. The data listed here are given as average product properties and should not be used to establish specification limits nor used alone as basis of design. The underlying tests were conducted at room temperature and (where possible) with 2 mm specimen thickness. For tensile and flexural tests a specimen width of 25 mm was used and is highly recommended to achieve representative results.

Akulon®은 자동차, 전자 및 전기, 가구 및 포장에 이르기까지 전 세계 고객이 사용하는 고성능 폴리 아미드 6 및 폴리 아미드 66 ​​재료 제품군입니다.

당사는 사출 성형, 블로우 성형 및 압출 용 Akulon® 등급을 제공합니다 (배리어 필름, 스톡 형태, 복잡한 튜브, 모노 및 멀티 필라멘트 포함).

성형 부품에서 재료는 넓은 온도 범위와 다양한 조건에서 뛰어난 기계적 특성과 함께 쉬운 설계 및 가공의 탁월한 균형을 제공합니다. 한편 압출의 경우 Akulon®의 강도, 탄력성 및 쉬운 가공이 시장 표준을 설정합니다.